Page 1 of 1
SAC Remote - No Meters
Posted: Mon Feb 08, 2021 6:36 am
by Mike Bizanovich
I have a strange thing going on. I did a new SAC Remote install on a new Win 10 computer. Everything is working including scenes, however I see no meter activity. Has anyone else run across this one?
Re: SAC Remote - No Meters
Posted: Mon Feb 08, 2021 7:39 am
by Bob L
Make sure the Meter Active options in the Mixer menu are checked.
Bob L
Re: SAC Remote - No Meters
Posted: Sat Feb 13, 2021 9:58 am
by Mike Bizanovich
Bob L wrote:Make sure the Meter Active options in the Mixer menu are checked.
Bob L
Came in today and the meters are working. Very strange. Never saw the "Meter Active" menu item before today, but they were enabled. Fluke, I guess. Thanks, Bob.
Re: SAC Remote - No Meters
Posted: Sat Feb 13, 2021 11:22 am
by Bob L
There is a reported issue with meters stopping after the engine has been on for more than around 24 hours... stopping and restarting the engine fixes it... I have tried to chase this down, but it is a bit hard to debug when it takes over 24 hours for the issue to appear.
Bob L
Re: SAC Remote - No Meters
Posted: Sun Feb 14, 2021 1:15 pm
by TomyN
Timestamps/Tick-counts to cotrol repeat - rate for sending VU-Meter data?
Re: SAC Remote - No Meters
Posted: Mon Feb 15, 2021 10:39 am
by Mike Bizanovich
Bob L wrote:There is a reported issue with meters stopping after the engine has been on for more than around 24 hours... stopping and restarting the engine fixes it... I have tried to chase this down, but it is a bit hard to debug when it takes over 24 hours for the issue to appear.
Bob L
Ah, that could be it! I was leaving the engine live testing the new laptop/remote as I was having issues with crashes of the remote. Finally got that sorted out with forced Single-CPU.