TCP/IP Master/Remote
Posted: Sat Mar 22, 2008 9:59 am
Howdy All,
I've done a first read though of the manual AND the release note!
The console works way better then I even hoped for
.
Hats off to BOB!
I'm pretty sure everyone is working on the console so what I'm working on is the remote/master funcations.
I have three PC in use.
1. Master - P4 3.2
2. Remote 1 - P4 2.66
3. Remote 2 - Thinkpad T61 (2 months old)
All PC are now in a group and have simple names.
All PC can be seen in the Network
All three are very stable running SAW and SAC
A default setup was configuried and saved.
Session name "FirstShot" save in new location D:\SAC\MXS\
The Remote Session
My first try was to have the Master opened configuried, saved and running a session.
Remote 1 is running in default with no changes since install.
Remote 2 is same as 1
Network note
First off I have found a possible an issue with the ThinkPad's NIC and my D-Link. It would not see the others, but I could see Remote 2 but could not access it. Back to the Linksys till I find out whats up.
With everyone up I first activated the Host/Master. Got my IP and a connection status.
Activated Remote 1 which after it connected gave me a popup saying "Trouble Opening File!" . After I "OK" the popup the Remote 1 showed the file location status as [\\Master\\SAC\MXS\FirstShot.mxs]
Activated Remote 2 with same as Remote 1
Everything so far works as if I'm at the Master
.
From manual:
You will then be able to operate the Master machine from the Remote machine, opening, closing and saving sessions, and controlling the consoles remotely.
I tried this and the Remotes could not open or save a session at the Master.
Hap
I've done a first read though of the manual AND the release note!
The console works way better then I even hoped for
.Hats off to BOB!
I'm pretty sure everyone is working on the console so what I'm working on is the remote/master funcations.
I have three PC in use.
1. Master - P4 3.2
2. Remote 1 - P4 2.66
3. Remote 2 - Thinkpad T61 (2 months old)
All PC are now in a group and have simple names.
All PC can be seen in the Network
All three are very stable running SAW and SAC
A default setup was configuried and saved.
Session name "FirstShot" save in new location D:\SAC\MXS\
The Remote Session
My first try was to have the Master opened configuried, saved and running a session.
Remote 1 is running in default with no changes since install.
Remote 2 is same as 1
Network note
First off I have found a possible an issue with the ThinkPad's NIC and my D-Link. It would not see the others, but I could see Remote 2 but could not access it. Back to the Linksys till I find out whats up.
With everyone up I first activated the Host/Master. Got my IP and a connection status.
Activated Remote 1 which after it connected gave me a popup saying "Trouble Opening File!" . After I "OK" the popup the Remote 1 showed the file location status as [\\Master\\SAC\MXS\FirstShot.mxs]
Activated Remote 2 with same as Remote 1
Everything so far works as if I'm at the Master
.From manual:
You will then be able to operate the Master machine from the Remote machine, opening, closing and saving sessions, and controlling the consoles remotely.
I tried this and the Remotes could not open or save a session at the Master.
Hap